Sensorwell
2CPSC1A2A
MICRO SWITCH 2CPS Series Cable Pull Safety Switch, Cable, Maintained Left Side, No Actuation Right Side, 2NC/2NO Direct Opening (Switch 1, Left: 1NC/1NO; Switch 2, Right: 1NC/1NO), 20 mm, Gold-plated Contacts, 24 Vdc Multi-cluster LED
The 2CPS Cable Pull Safety Switch provides readily accessible
emergency stop over a long, linear distance. It is a
cost-effective means of providing this emergency stop signal
compared to multiple emergency stop push buttons. (Cable Pull
Safety Switches are not, however, to be used as a means of personnel
safeguarding. They may be used to prevent further injury or
damage to equipment when used for emergency stop signaling.)
The 2CPS Series Cable Pull Safety Switch is designed to provide
emergency stop protection for exposed conveyor lines. The
internal mechanism latches on both slackened cable (push) and
pulled cable. This capability enhances productivity by eliminating nuisance stops due to
variations in temperature, stretch of cable over time, and other
application variables.
A line in the midpoint of the cable tension window indicates
proper cable tension, providing easy and intuitive set-up. The
direct acting switch contacts are held closed when the actuating
cable is under proper tension and the reset knob is set to RUN.
When the actuating cable is pulled, slackened or broken, a cam
positively opens the NC (Normally Closed) switch contacts. The
snap action, trip operation causes the switch contacts to change
state and mechanically latch almost simultaneously when the
cable is pulled, slackened or broken. The NC switch contacts
remain open until the 2CPS is reset by properly tensioning the
cable and manually rotating the reset knob.
When the direct acting switch contacts open, the auxiliary contacts
also actuate (open contacts close and closed contacts open).
The auxiliary contacts are electrically isolated from the direct
acting switch contacts. These NO (Normally Open) contacts may
be used for monitoring or signaling.
The 2CPS complies with: Low Voltage Directive 73/23/EEC, as
amended by directive 93/68/EEC; Machinery Directive 98/37/EEC
only as the directives relate to the components being used in a
safety function; IEC/EN60947-1; IEC/EN60947-5-1; IEC/EN60947-5-5; UL, CE, CSA, SIL 3 capable.
2CPSC1A2A
Produkt Merkmale
Kenndaten
- Positive opening operation of normally closed contacts
- Choice of 2NC/2NO or 3NC/1NO contact configurations
- Maximum cable length in a single direction is 76 m (250 ft) for a combined length of 152 m (500 ft) in dual directions
- Choice of three actuator configurations
- Removable contact block version available
- Large wiring cavity with straight-through wiring
- 24 Vdc or 120 Vac bright, multi-cluster LED status indicator light available
- Gold-plated contacts are standard
- Die-cast zinc housing
- Optional hardware packs available
- UL, CE, CSA, SIL 3 capable
Anwendungsbereiche
- Long conveyor systems found in warehouses and distribution centers
- Conveyor systems having a high amount of vibration
- Conveyor systems that experience wide temperature swings
- Long conveyor systems where easy through wiring, or highly
visible trip status is required - Perimeter guarding where hosedown conditions are present