Sensorwell
060-0287-13G
Model A-105 Flush Diaphragm Pressure Transducer; 100 psi to 15,000 psi; Flush-Mount Design; 17-4 PH Stainless Steel, Wetted Material; Miniature Footprint; 0.50 % Accuracy
The Model A-105 gauge pressure transducers are manufactured with a unitized 17-4 PH stainless steel, wetted diaphragm. The advantage of this type of design is that a thin diaphragm and heavy sidewalls are made from one piece of stainless steel. This unitized diaphragm is rugged, but at the same time, can be made thin enough to measure low pressures. Available pressure ranges span from 100 psig to 15,000 psig. These models can be used in corrosive fluid environments. The Model A-105 has welded electrical connectors as an integral part of the transducer body and recommended for applications involving rough handling, or where an all-welded, stainless steel transducer is required. All units have four (4) active bonded strain gauges arranged in a Wheatstone-bridge configuration.
060-0287-13G
Produkt Merkmale
Kenndaten
- 100 psig to 15000 psig range
- Flush mount design
- No dead volume
- Miniature footprint
- Stainless steel
- CE approved
Anwendungsbereiche
- Engine and transmission test stands
- Fluid pump pressure
- Fuel line pressure and fuel/air ratio
- Brake assembly test
- Tire manufacturing mold pressure control
- Brake and accelerometer cable test
- Air bag system fill pressure
- Pressure brake testing, hydraulic sensor: Brake pedal forces, ABS pressures
- Well stimulation
- Coil tubing
- MWD
- Wellhead measurement
